Skip to contentSkip to search
Kaplan Publishing: Black Friday countdown

PM*** F5 December 2014 Exam was.. Instant Poll and comments ***

Oopentuition_teamAdmin11y ago

Please vote in our Instant Polls about the F5 December 2014 Exam.

*** F5 December 2014 Exam was.. Instant Poll and comments *** poll results *** F5 December 2014 Exam was.. Instant Poll and comments *** poll results *** F5 December 2014 Exam was.. Instant Poll and comments *** poll results Please note, the ACCA have asked us to allow posting comments only after 5pm UK time.
Former userFormer user11y ago#121
Yeah I include 300 for the overtime
GGvtftf11y ago#122
Still you are close and you will get enough points
Former userFormer user11y ago#123
Hope so mate
Former userFormer user11y ago#124
What did you get for the 1st question on learning curve? I got the selling price of 419
GGvtftf11y ago#125
The incremental time for 8th unit was 3.04 hours, you multiple this by 15 llabor cost and add 230 of material cost then
SSafiyyah11y ago#126
Lol got 9455 didn't include the 10%. Its an apportioned fixed cost. Oars are not relevent.
GGvtftf11y ago#127
Haha bro got 9455 but decided to add 10 percent in any case :D still we got it right, i assume;)
Former userFormer user11y ago#128
Was it precisely 70% and if yes could you please share calculations? I got 68,6%. Actual time for 1st - 12,5 Total for 8 - 34,3 Average for 1 =4,2875 For 2 average time = 8,575 L rate = 8,575/12,5 = 68,6%. Compared 1st with 2nd as they are next to each other (doubling rule exist). Probably i am wrong but this seemed reasonable and good enough under the pressure in exam. :)
CChris11y ago#129
Strategic planning is external focus. D & b we're correct as $24 per hour and $5.25 respectively. Do not employ manager as 1309 loss. TPAR were 1.4 and 1.6.most seem to have forgotten that total time available was 2400 x 3 stylists = 7200 hours. Not 2400 hrs which gives less than 1 for ratio.
Former userFormer user11y ago#130
Yeah that's what I did, then multiplied by 1.5 for the markup
JJames11y ago#131
Think I got 9455. No fixed should have been apportioned as they were not incremental therefore regardless of the project would have been included
CChris11y ago#132
1300 loss - typo. Previous poster was correct on relevant costing I last point. Only overtime of supervisor was relevant. One of the mats needed 30 kilos of new price ($8.50) and 20 of current as in continued use ($8.20 x 20) from memory.
GGvtftf11y ago#133
Sure, mate))) 12.5 hours for first unit, then this is the average time as well. As you tightly stated, average time for 8 units is 4.2875. Then, 4.2875 = 12.5 multiplied by r in powevof 3, then you just find r
JJames11y ago#134
@chris1975z said: Strategic planning is external focus. D & b we're correct as $24 per hour and $5.25 respectively. Do not employ manager as 1309 loss. TPAR were 1.4 and 1.6.most seem to have forgotten that total time available was 2400 x 3 stylists = 7200 hours. Not 2400 hrs which gives less than 1 for ratio.
Got the D and B like yourself, however didn't catch the 3 stylists bit for some reason, quite annoying! Will I lose only one mark if everything else was right?
CChris11y ago#135
I got 3.04 for 8th unit and also 70% revised learning curve and therefore cheaper.
GGvtftf11y ago#136
Mate, in this case 20 is irrelevant, as there is no use for it in general. But 30, as you rightly stated, should be purchased additionally at 8.50
GGvtftf11y ago#137
Mate, please check bpp revision kit questions 16 and 17, you will understand why your tpar calculations are wrong ;)
CChris11y ago#138
Nah, only a couple at most. Also James, I think you took off $8 as Mats for throughput on both services. The cuts only had mats of $0.40 and other one had $0.40 + $7.60.
GGvtftf11y ago#139
It was D and A. Not d and b. for d it was 30, for a it was 7.6
CChris11y ago#140
20 is relevant as in constant use. Therefore needs replacing and is relevant cost.
GGvtftf11y ago#141
Senior stylist was the only bottleneck resource, so that you do not multipy by three, i think you just missed this point
MMatsatsoSupporter11y ago#142
@emo777 said: Mate, in this case 20 is irrelevant, as there is no use for it in general. But 30, as you rightly stated, should be purchased additionally at 8.50
material price is always relevant. either as cost, or as saving.
GGvtftf11y ago#143
Chris, i clearly remember they stated that 20 was not of use. Out of total 500, only 480!were constantly used
CChris11y ago#144
Gvt. You're wide of mark mucker. You wanna take Pepsi challenge on highest pass mark? Tpar covers total time available on scarce resource. Are 3 stylists not the the bottleneck and therefore 3 x 2400 hrs?
GGvtftf11y ago#145
Again, mate, check the book please, if there is no further use for material and it cant be resold, then its relevant cost is zero. As for our question, you just use these for the order. If i were wrong, i would not have been able ti calculate cost of 9455, as many others got
CChris11y ago#146
From memory they were to be used on a product in 4 Weeks time and therefore would need replacing and therefore all relevant. Cost per hour = all costs except materials/TOTAL time on bottleneck. 3 x stylists at 2400 hours each = 7200 hours. You think an acca paper is gonna how both TPAR lower than 1 when never before.....
Former userFormer user11y ago#147
@chris 2400hrs s the total time stylists are expected to work for the year i.e 8 hrs a day, 6 days a wk,50 wks a year. Why r u multiplying by 3?
CChris11y ago#148
Either way on the 20 kilo it's 1 mark out of 100 at most so still happy days. Loved this paper. Suggest we wait for Mr Moffat to post his answers to TPAR ratio rather than wasting our unproductive time going too and fro!!
CChris11y ago#149
Because there are three stylists?
CChris11y ago#150
If you had 1 machine available for 100 hours and this was bottleneck, surely 3 machines would mean total time available on bottleneck would be 300 hours?
Topic lockedNew replies are closed.