PM*** F5 June 2016 Exam was.. Instant Poll and comments ***
Hi my mcqs are all guess. Sec b was ok though but still I doubt.
Thought I did fairly well, short questions threw me a bit but eventually after reading through them a few times they were ok. Question 5 was handy decision making question. I found Question 4 to be the hardest.
Lack of time, I had to rush a bit the MCQs. I think some of the MCQs are too long/too many calculations to do considering they give 2 points each only.
Question 4 was the hardest in my opinion as there was a lot to read and a lot of data. It was about Transfer pricing which I thought I studied well but at that point in the exam I didn't have a fresh mind to answer properly as it was the last one that I attempted.
just hoping to have done enough to pass..
Typical F5 exam. I think I did fairly well this time around. MCQs were fine as well as question 1, 2, 3, 5. Question 4 was the hardest for me.
MCQ were okay, guessed around 4. Q 2 on breakeven and 3 on ABC were pretty straight forward. Forgot how to calucate the sales market and volume share variances for Q1, 4 & 5 were tough.
What were the Mcq answers?
The Q paper ws actually easy...bt i wsnt prepared
I hope whoever is marking my paper is in the middle of a nervous breakdown and/or on drugs. That's the only way I'll pass.
in Q4 I supposed to transfer total 120 unit because of spare capacity
in Q5 I closed school 3 since got benefit from closing it.
what was the learning rate in 14th multiple choice i got 75% but used very complicated calculation
The exam is fairly easy to pass if you prepare well. The examiners come up with lots of easy questions and a little bit of difficult ones. It is not as difficult as what they usually say.
our answers are similar:
closed school 3
75% learning rate too
could transfer up 140k units (however, M only needed 120K)
TP: 37
Sensible range (24-37) for goal congruence
for revising mark up 37.8%
mark up same 37.8%, ROI 35% but not sure still what is correct since asset can be either cost or net book value
rolling bug was:A
cant remember rest
BEP differ was 24000 I guess!
I strongly feel that I got at least 18 mcqs correct.
Q2:ran out of time
Q5: so confusing but closed school 3. I just compared cost saved by closing schools vs cost by running them
part b; remaining staff morale, likelihood of 80% pupils will join school 1&2, rules and regulation from govt for closing school down penalty etc, accuracy of fixed cost calculation, will pupils deffo come back after 3 years.
Q4: Trans pricing- went well
Q3: ABC was easy
Q1: market size variance: wasn't sure but still did alright I guess.
what was the answer for 1st mcq?
i was confused between a &b
but ticked A at last.
what was answer in 4th msq?
@joey
+1
4th was C revised mark up-37.8%
Think it was A, not sure though lol
Can someone explain to me how to tackle question 14 from the mcqs?
I am still not sure.
Calculate learning rate.
First 10 unites took 120 hours.
Following 30 units took 150 hours.
Thanks.
The mcq are hard..most of them I don't know how to do,jz guessing..
The Q4 and Q5 are hard also!
Hopefully I can pass the paper! God bless!!!
market size variance:
1st product favourable
2nd product adverse around i think 120000
market share variance:
1st prodct was favourable but less than from its planning.
2nd product was adverse around 15000.
ABc question: both types of waste disposals have around 80 something cost and was less than their original cost.
transfer price ques: suggested quantity 140000 but other division only need less than this.
school question : 3rd school need to b closed.
BE question: interpreted well.
Q1- market size and market share , did same sort of calculation as planning and operational
Q2- break even chart
Break even was at 500
100- cost 30,000
200 cost 60,000
300 cost 90,000
400 cost 120,000
500 cost 150,000
So for each 100 athletics , cost was going up by 30,000
Fixed cost had semi variable element
Q3- production cost per unit 1W $75 something and $85 something for the other one
Q4- transfer pricing. Messed up completely
Q5- closed school 1 as it had the highest loss among all other and allocated the 80% of students to other two schools and relocation of 50% staff to other schools , messed up in This question too ???
mCQ's were disaster.
Don't think I will score more than 30% in the whole paper even though studied day and nights 2 months
TP Quetions - suggested a TP price between 20 (VC) and 37 (external). Should transfer all units as has the capacity to do so.
BEP Q - Discussed the semi variable, step up, difference selling prices etc.
Q5 - Sugguested to close school 2, found this Q hard. Pretty much totalled the costs of disposal and went from there.
ABC Q - I sgot around $75 for the first, and $99 for the second? Anyone near me?
Guessed the MCQ's mentioned for learning rate and mark up, what did you all put for that through put MCQ for multiple limiting facors (labour and machine hours)?Really stumped me!!
Overall tough paper, best of luck to everyone in 6 weeks!
formula Avg time for units/time took for first X (r)
so i considered the question in batches of ten instead eg;first batch took 120hr, further 3 batches 150
average time per batch 67.5 (120+150/4) DIVIDED BY first batch 120
=0.5625^(R2) R= how many times doubling occured?
2times so r2
75% or 0.75
1+1=2+2=4
@seannyd said: TP Quetions - suggested a TP price between 20 (VC) and 37 (external). Should transfer all units as has the capacity to do so. BEP Q - Discussed the semi variable, step up, difference selling prices etc. Q5 - Sugguested to close school 2, found this Q hard. Pretty much totalled the costs of disposal and went from there. ABC Q - I sgot around $75 for the first, and $99 for the second? Anyone near me? Guessed the MCQ's mentioned for learning rate and mark up, what did you all put for that through put MCQ for multiple limiting facors (labour and machine hours)?Really stumped me!! Overall tough paper, best of luck to everyone in 6 weeks!I ranked B then A then C for the limiting factor mcq.
@samara182 said: I think so tooIt was selling price for disposal
for first two a and b machine hours bottle neck
for c it was labour hours (in c machine could produce more but LABOUR was slowing down
since its in same factory same cost, we needed two rank them by return per factory hours
for me it was: A B C
no only two
effectiveness means how successful we are.?
so no of students made it to further education on schedule?
and no of students passed or some sort of success etc?

